There might be a few situations where you need more flexibility than what the clock UI can provide. In that case, you will need some help from the command line and registry. To manually synchronize the clock with a time server using the command line : net time \\<ntp_server> /set /yes NOTE : Replace <ntp_server> with… Read More »
Upgrading from vCenter 5.5 to 6.0? Then you might have run into the following issue during the setup : The range of ephemeral TCP ports on this system is 1025 to 65534. This range of ports is too large and the system must be reconfigured to use a smaller ephemeral port range before the install can… Read More »
If the error message below show up while you are trying to modify the virtual hardware of a VM, this mean that the host that you are editing the VM from is linked to a vCenter server. Reconfigure virtual machine <VM_Name> Access to resource settings on the host is restricted to the server that is… Read More »
If you encountered the following error trying to connect to a POP3 account on your Microsoft Exchange mail server, this might indicate the following issues : – The POP3 protocol isn’t enabled for this account ; – The login type you are trying to use isn’t currently supported by the server. This usually happen when… Read More »
If you own the 1st generation magicJack and you have upgraded your computer from Windows 7 to 10, you may have noticed the following error message while starting the magicJack application : magicJack cannot access the Internet. Please click here to start magicFix. This message show up even though your computer is connected to the… Read More »
You probably noticed the following output on your console after logging to your newly installed CloudLinux server : perl: warning: Setting locale failed. perl: warning: Please check that your locale settings: LANGUAGE = (unset), LC_ALL = (unset), LC_CTYPE = “UTF-8”, LANG = “en_US.UTF-8” are supported and installed on your system. perl: warning: Falling back to… Read More »
Ending up with the following error trying to install CloudLinux? You have third-party kernel module rpm installed. It’s not compatible with CloudLinux kernel. Please contact CloudLinux support at https://helpdesk.cloudlinux.com In my case, this was because of the “kmod-vmware-tools-vmxnet3” module, since it was on a VMware guest machine. Since removing it isn’t an option and I… Read More »
Ending up with the following error trying to join a server or workstation to an existing Active Directory domain? The following error occurred attempting to join the domain “domain.tld”: The request is not supported. Additionally, if you have a look at the EventViewer, you can see the following log entries under the following logging facility… Read More »
You probably have seen the following on your Juniper JunOS device : dcd[15676]: ae60 : Warning: aggregated-ether-options link-speed no kernel value! default to 0 dcd[1103]: ae60 : aggregated-ether-options link-speed set to kernel value of 1000000000 This mean that your aggregated interface (ae) does not have any link-speed statement. By the book, this statement should be… Read More »
LogMeIn remote control software cannot be removed without traces by just removing the .app icon/folder from the Application directory like you used to do with the majority of software (it will leave the finder tray icon, will attempt to start on boot, etc.). There is an easy way using the uninstaller script to achieve this… Read More »